Click bang and fail to fire
Posted: Tue Oct 01, 2013 12:05 pm
Righto now I'm back from the queens I have taken my gun apart for new barrels and to work out why I'm getting firing issues.
Took the firing pin out and there was some oil under the spring on the pin itself. Also inside the bolt body there was oil as well which I have cleaned both out and dried so it's not there anymore. I was under the impression the internals of a bolt must be dry. Correct?
Another thing I'm looking at is the sear on the top of the kelbly competition trigger isn't contacting the firing pin square. I greased the side of the channel it runs in over the weekend as I was thinking that due to the not square contact the pin might have been running down the channel off centre and slowing the pin down. All strikes on primers were fairly light.
Any other thoughts?
Took the firing pin out and there was some oil under the spring on the pin itself. Also inside the bolt body there was oil as well which I have cleaned both out and dried so it's not there anymore. I was under the impression the internals of a bolt must be dry. Correct?
Another thing I'm looking at is the sear on the top of the kelbly competition trigger isn't contacting the firing pin square. I greased the side of the channel it runs in over the weekend as I was thinking that due to the not square contact the pin might have been running down the channel off centre and slowing the pin down. All strikes on primers were fairly light.
Any other thoughts?