OzFclass

Hi all,

I am looking for a pair of Remington 700 Action Screws, I have a surgeon 591 in an HS Precision stock and the ones I have do not have enough thread engagement in the action.

Please msg me on here if you have any or know where I can buy some

Thank you,

Tom.

Should be 1/4" UNF thread. Do you have a fastener supplier near you?

I'll need to check tomorrow, but I think I have a pair of high quality stainless screws that I bought from the US but have not used. They are overlength ready to be cut to size.

Standard hex head socket on the end.

BATattack wrote:Should be 1/4" UNF thread. Do you have a fastener supplier near you?

I have been told there’s a place in brookvale otherwise I have ordered some UNF bolts online in the past for other things, worth a look there.

adamjp wrote:I'll need to check tomorrow, but I think I have a pair of high quality stainless screws that I bought from the US but have not used. They are overlength ready to be cut to size.

Standard hex head socket on the end.

That sounds promising, I’ll check back tomorrow night cheers.

@locks,
Best fastener supplier in Aus with free post;
https://www.boltandnut.com.au/1-4-x-28- ... cap-screws

Easy way is to buy 1 1/4 longs and cut to length.
Usually appx 0.75" and 1.00" plus 5-20thou (depending on stock and whether you're using Nord-Lock washers).

Note bulk rates means it's usually better to buy more(10), keep some spares and give some to mates.

adamjp wrote:I'll need to check tomorrow, but I think I have a pair of high quality stainless screws that I bought from the US but have not used. They are overlength ready to be cut to size.

Standard hex head socket on the end.

did you happen to have a check if you had those screws Adam?

Thanks, Tom.