Hello, looking at buying electronic scales to weigh powder charges after they come out of the auto thrower. Any one know a good set.
I see the Gem...
Last post
Strain gauge scales such as the GP can weigh to within 0.02 grains if the load being weighed is static. If you trickle, a strain gauge scale has more...
Ok , with Great Request from heaps of people ! ..... arrrh! Well a couple of people haha! The 280 Ackley blog is up and running. It's a little early,...
Last post
Well , finally, some good news for 280 ai faithful! I had a good training session with the 280 ai today in blustery mirage conditions today at 1010...
Not sure if its been covered before but what's the ruling on front plates that have sides on them to stop bipods slipping off it came up at a resent...
OK so I have been doing a bit of pre Queens reading and was looking at the target Dimensions and there are a couple of things that I don't quite get...
Last post
I agree and I have an Imperial and a MOA per range version in Excel but that was taken straight out of the rule book.
As we will be at the Queens for the 1st time and regularly do a few OPMs on manual targets, we are looking for recommendations for suitable...
Last post
If you are going to Vic Queens, I can bring a $2500 top of the line Ziess binoculars, or a $400 Chinese spotting scope and tripod for you to use and...
I find my labradar l can check speeds one day then next day same time and temperature speeds are 20fps different. Do any one else have this problem?
Last post
How many bars on the bar graph on the left hand side of the screen are you typically getting? Low bar count indicates poor alignment and affects the...
Can anyone identify what make this trigger is? Attached to an Omark 44 at the moment. 20190316_164545.jpg
Last post
I have a Kiwi branded trigger that is fitted to an old P14 conversion from around the time of changeover from 303 to 7.62. It is a very nice trigger....
Hello,
Has anyone used Reloader 15 in a 308 with 175/185 projectiles.
ADI powders are sometimes hard to get.
Regards Daffy.
Last post
Reloader 15 is very similar to 2208. Should be similar charge weights. Mate has used RL17 in a 308 with heavies, but abandoned it due to temperature...
I got a new 32 inch 1/11 twist Barrel which shoots the 155VLD's pretty good with BM8208. Thought I would try testing the heavier 210s . Any one got a...
Last post
throat length determines available powder charge and pressure
long throats required for max velocity
If a 155 throat then ???
1/11 possibly marginal...
A friend asked me about loads for 185 gr. projectiles for 308W.
I had no idea so I promised I'd ask.
He's shooting 185 gr. projectiles in a 308W and...
Last post
May be too late but I have found either .010 or .005 jump
Okay so just wondering what everyone one thinks are the best recoil pads available for prone style shooting. This is in the interest of the fact that...
Last post
Either the op is very short or the kids are tall , I have not seen a case yet where a 12 yo will not run in to LOP issues when using their parents...
Just sitting here bored and started to think about about the different cal wild cats that are around in 22 cal. I was wondering if anyone has necked...
Last post
pete,
because it seemed like a good idea at the time.
bruce.
Looking for a starting load with 2213sc for a SAUM using 183 Sierras. Barrel is 32"
Last post
My first choice would usually be straight to 2209.
I tried 2213sc in other barrels either to reduce pressure/barrel erosion for a practice barrel or...
Just curious if anyone has used the NRRA 155.5 Australian Outback ammo or done any real testing on it.? I've reloaded for years now and and can count...
Last post
I guess if you find reloading a chore then you may consider the cost of your time. Personally I enjoy reloading. It is something to do with my sport...
With the latest small shipment of Berger’s bought in by BRT seeing 7mm pills now up to 90c ea my next order will likely be for Kens new 184gr bullet....
Last post
And here’s the groups.
Yes I shot groups with a 1.1gr powder spread. Hybrids grouped very well considering the powder spread.
Following a glowing endorsement from Jason Mayers, I purchased a Huntsman barrel tuner today. I will be fitting it to a 308 ftr rifle I have been...
Last post
Hope to be available one of the days Geoff. Bloody fires down here and floods up North, the climates is erratic. Wish the politicians would could see...
Looking at some options for running an F-open .308 for long range (simply because we've got a spare barrel and all the gear, rather than...
Last post
Always got the problems of energy limits such as Belmont and Bendigo though Rod.
I had a barrel some years ago that could break that limit with 215H...
Just recently fitted a new Maddco barrel chambered for .284W. It took about 2 weeks from order to delivery. I have never had a barrel that ran in so...
Last post
Similar experience with two 6.5 Madco barrels recently. Run in basically superfluous. And they both shoot very well.
Can anyone fill me in on the jongmans actions please. I came across one this morning and and it's got me thinking, but I don't know anything about...
Last post
Quite a long time ago I was involved in fitting a peep sight to a Jongman's action shooting a 223. Although it shot fairly well (TR 223 back then) I...
Hi to all.
I was contacted by a member asking for KG USA products. I'd like to inform the forum that as of 2014 Australasia Coatings is the importer...
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
Menu
Newest members