Hi All,
I have just finished a carton (1000) of the above. I found a difference in colour of the priming compound. 67 had a yellow compound compared to the normal red compound. I did not load these as I was not sure what they were. I checked one out buy firing off in an empty case and it ignited..
Has any one else found this anomaly. When I found the first few I contacted Federal but received no reply. I do not intend using these unless I can be convinced it is safe to do so. But I will probably give them the deep 6 when I go fishing next. It will be interesting to see what the next carton produces. Any comments on info. welcomed.
Cheers,
Trevor.
Federal 210M Primers
Moderator: Mod
-
- Posts: 270
- Joined: Fri Sep 30, 2005 2:37 pm
- Location: PERTH
Re: Federal 210M Primers
Trevor , Federal only use yellow compound BUT what they do do is use Red and Purple dye on the anvil to show the difference between a STD and magnum primer at the factory. I have seen some batches with minimal red dye and others with lots of Red dye in the 210M. Makes no difference to performance from what I have seen.
BRETT BUNYAN F CLASS OPEN SHOOTER W.A.
-
- Posts: 1384
- Joined: Tue Aug 24, 2010 12:11 pm
-
- Posts: 289
- Joined: Sat Sep 12, 2015 2:07 pm
Re: Federal 210M Primers
Thanks Brett and Barry for the information. I have used heaps of these and this is the first carton I have found this difference. I will now use these, but will not mix them in a loading session. The replies are much appreciated.
Cheers,
Trevor.
Cheers,
Trevor.
Return to “Equipment & Technical”
Who is online
Users browsing this forum: No registered users and 162 guests