Got one of these bad boys the other day and with a couple of barrels chambered with the same reamer and the same headspace, and an earlier one a little larger, it has been a pain adjusting the die for different barrels and cases. Now with this gadget its just loosen the die in the press, undo the locking key, spin the dial to the required number to go up and down in headspace (adjustments are pretty spot on) and lock the key then re lock the die in the press. Takes all of about 4 seconds.
Thoroughly recommend them if anyone has multiple barrels that vary slightly with headspace.
http://bulletin.accurateshooter.com/201 ... r-reports/
PMA Tool micro die adjuster
Moderator: Mod
Return to “Equipment & Technical”
Who is online
Users browsing this forum: No registered users and 53 guests