Hi just after some advice on 6 brx dies. can you use just a standard set of BR dies for full length and neck sizing?
Thanks
Jake
6mm brx dies
Moderator: Mod
-
- Posts: 136
- Joined: Wed Nov 17, 2010 10:42 pm
- Location: Sutherland Shire
Re: 6mm brx dies
Hi Jake,
I shoot a 6BRX and because the shoulder is blown forward 2.54mm you'll need a genuine 6BRX FLS die to reform fired cases.
However 6BR neck sizing and seating dies can be used with a 2.54mm thick steel spacer located between the die base and shell holder such that when the neck sizing die is fully closed in the press, the shoulder clearance meets 6BRX requirements.
The turned up SS steel spacer I used is OD 19mm ID 12.5mm x 2.54mm thick
Hope this helps
Peter
I shoot a 6BRX and because the shoulder is blown forward 2.54mm you'll need a genuine 6BRX FLS die to reform fired cases.
However 6BR neck sizing and seating dies can be used with a 2.54mm thick steel spacer located between the die base and shell holder such that when the neck sizing die is fully closed in the press, the shoulder clearance meets 6BRX requirements.
The turned up SS steel spacer I used is OD 19mm ID 12.5mm x 2.54mm thick
Hope this helps
Peter
You do not have the required permissions to view the files attached to this post.
Good judgement comes from experience, experience comes from bad judgement!
-
- Posts: 41
- Joined: Thu Apr 11, 2019 12:28 pm
- Location: Townsville
Re: 6mm brx dies
Okay no worries thanks peter i think i might just get a whole 6BRX die set from whidden gunworks and be done with it!
Cheers
Cheers
-
- Posts: 136
- Joined: Wed Nov 17, 2010 10:42 pm
- Location: Sutherland Shire
Re: 6mm brx dies
Good choice, I use a Lee Collet Die made by Lee's custom shop, no runout and necks are always coaxial.
Chs
Peter
Chs
Peter
Good judgement comes from experience, experience comes from bad judgement!
Return to “Equipment & Technical”
Who is online
Users browsing this forum: No registered users and 52 guests