Barnard fit an Musgrave inletted Don Brooks Stock

If you shoot full-bore, then you're welcome to use this forum to discuss your sport.

Moderator: Mod

Message
Author
Wayne_tri62
Posts: 25
Joined: Tue Aug 16, 2016 2:33 pm
Location: Muckadilla Rifle Club

Barnard fit an Musgrave inletted Don Brooks Stock

#1 Postby Wayne_tri62 » Thu Dec 29, 2016 5:54 pm

=D> Greetings all
Quick question on action fitting. Would a Barnard Action fit easily into a Don Brooks aluminum stock, that is currently in-letted for a Musgrave Action. Current barrel is MAB 30 inche'er..
Would there be any real problems.
Thanks

Barry Davies
Posts: 1383
Joined: Tue Aug 24, 2010 12:11 pm

Re: Barnard fit an Musgrave inletted Don Brooks Stock

#2 Postby Barry Davies » Thu Dec 29, 2016 6:50 pm

Wayne,
It would not be a straight forward job as the Musgrave is a flat bottom receiver whereas the Barnard is round.
Without seeing the stock I would guess it could probably be machined out and a Barnard V Block fixed in.
Bolt handle may be in a different position relative, as with the trigger and T/D screws

Wayne_tri62
Posts: 25
Joined: Tue Aug 16, 2016 2:33 pm
Location: Muckadilla Rifle Club

Re: Barnard fit an Musgrave inletted Don Brooks Stock

#3 Postby Wayne_tri62 » Thu Dec 29, 2016 10:08 pm

Sir...

Thanks heaps for your input,,,
I was looking at a budget alternative,,,
thanks again and Happy New Year


Return to “Full-bore/Target Rifle”

Who is online

Users browsing this forum: No registered users and 11 guests