Greetings all
Quick question on action fitting. Would a Barnard Action fit easily into a Don Brooks aluminum stock, that is currently in-letted for a Musgrave Action. Current barrel is MAB 30 inche'er..
Would there be any real problems.
Thanks
Barnard fit an Musgrave inletted Don Brooks Stock
Moderator: Mod
-
- Posts: 25
- Joined: Tue Aug 16, 2016 2:33 pm
- Location: Muckadilla Rifle Club
-
- Posts: 1390
- Joined: Tue Aug 24, 2010 12:11 pm
Re: Barnard fit an Musgrave inletted Don Brooks Stock
Wayne,
It would not be a straight forward job as the Musgrave is a flat bottom receiver whereas the Barnard is round.
Without seeing the stock I would guess it could probably be machined out and a Barnard V Block fixed in.
Bolt handle may be in a different position relative, as with the trigger and T/D screws
It would not be a straight forward job as the Musgrave is a flat bottom receiver whereas the Barnard is round.
Without seeing the stock I would guess it could probably be machined out and a Barnard V Block fixed in.
Bolt handle may be in a different position relative, as with the trigger and T/D screws
-
- Posts: 25
- Joined: Tue Aug 16, 2016 2:33 pm
- Location: Muckadilla Rifle Club
Re: Barnard fit an Musgrave inletted Don Brooks Stock
Sir...
Thanks heaps for your input,,,
I was looking at a budget alternative,,,
thanks again and Happy New Year
Thanks heaps for your input,,,
I was looking at a budget alternative,,,
thanks again and Happy New Year
Return to “Full-bore/Target Rifle”
Who is online
Users browsing this forum: No registered users and 2 guests