Dies advice for 284 Win

For general announcements, and anything which does not fit into one of the categories below.

Moderator: Mod

Posts: 187
Joined: Mon Mar 18, 2013 4:21 pm
Location: Waikato NZ (Ex Tyabb)

Re: Dies advice for 284 Win

#16 Postby 6.5x55ai » Wed Sep 13, 2017 5:59 am

I have to say I was disappointed with my Redding (and I love Redding products) Comp Shellholder Set. I bought it when they first became available. The steps between the shellholders are inconsistant and the 2 middle ones mic the same grrr. Plus I load for 4 different cartridge head diameter families and there is no way I will be purchacing another three sets to cover my other catridges.

A better solution I have found is Skip Otto's 7 shim set which go under the die's locking ring. The shims go 3, 4, 5, 6, 7, 8, 10 thou and give very flexible range of adjustments.

Posts: 67
Joined: Fri Jun 16, 2017 9:43 am
Location: Cowell SA

Re: Dies advice for 284 Win

#17 Postby Toddy » Wed Sep 13, 2017 8:46 am

Too true Gary. Makes a lot of sense.

Posts: 23
Joined: Sat Nov 21, 2015 11:35 pm
Location: W.A.

Re: Dies advice for 284 Win

#18 Postby JasonR » Sat Sep 30, 2017 10:39 pm

If your current dies are sizing the brass sufficiently at the .200” line and the shoulder and you are getting enough bump then the die is doing it’s job.

Return to “General Forum”

Who is online

Users browsing this forum: No registered users and 5 guests